Sea gull lighting 16006-15 Instrukcja Obsługi Pobierz pdf

16002-15

INSTRUCTIONS FOR YOUR NEW

REMOTE FAN CONTROL SYSTEM

CAUTION:

This remote only works with some fans in sloped ceiling model.

Do not use fan speed control in canopies where the mountng is

not as described in figure 6,7.

A. SETTING THE CODE ON YOUR NEW REMOTE (Fig. 1):

1. Remove battery cover

* Refer to pg 5 for removing battery cover.

2. Slide code switches to your choice of UP and DOWN positions.

Factory setting is all UP. Do not use this setting.

•Use ball point pen or small screwdriver.

•Slide firmly up or down.

B. SETTING THE CODE ON YOUR NEW CONTROL UNIT (Fig. 2)

1. Slide code switches to the same positions as set on

your REMOTE.

NOTE: The code switches on the TRANSMITTER and the RECEIVER

UNIT must be set to the same positions to work.

The item “IC:” before the r

adio certification number only signifies that

Industry Canada T

echnical specifications were met.

Oper

ation is subject to the following two conditions: (1) this device ma

not cause interference, and (2)this device must accept any interference,

including interference that may cause undesired operation of the device.

WARNING - HIGH VOLTAGE

Before Connecting the Control Unit:

•Remove electrical power from circuit to be used.

•Household power can cause SERIOUS INJURY or

DEATH.

•Wiring must meet all local electrical code require

ments.

Code switches

Fig.1

Code switches

Fig.2

Transmitter

Receiver

1 2 3 4 5 6

16002-15 1

Podsumowanie treści

Strona 1 - 16002-15

16002-1516002-15INSTRUCTIONS FOR YOUR NEW REMOTE FAN CONTROL SYSTEMCAUTION: This remote only works with some fans in sloped ceiling model.Do not use f

Strona 2

16002-15LIMITED WARRANTYA. GEOGRAPHIC SCOPE - This warranty applies to products purchased in the United States and Canada.B. What is Covered? Any def

Strona 3

16002-15INSTRUCTIONSFOLLOW ALL SAFETY INSTRUCTIONS IN YOUR CEILING FAN INSTRUCTION MANUAL.*REMEMBER TO REMOVE ELECTRICAL POWER BEFORE STARTING WORK.*W

Strona 4

16002-1512. Push the connected wires up into the junction box.13. Lay the BLACK Control Unit wire (Antenna) on top of the Control Unit.14. FOR FANS

Strona 5

16002-15The wall control transmits the command signals via radio waves to the receiverinstalled in the fan’s hanging bracket or on the fan. The receiv

Strona 6

16002-15Remote Control Transmitter Features:FAN SPEED Depress “l dot” for low speed, “2 dots” for medium or “3 dots” forhigh. To turn fan off press sq

Komentarze do niniejszej Instrukcji

Brak uwag

Sea gull lighting 16006-15 Instrukcja Obsługi

Przeglądaj online lub pobierz Instrukcja Obsługi dla Akcesoria do montażu na ścianie i suficie Sea gull lighting 16006-15. Sea Gull Lighting 16006-15 Instructions / Assembly Instrukcja obsługi

Podsumowanie treści

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Akcesoria do montażu na ścianie i suficie Sea gull lighting 16006-15