Sea gull lighting 94538-965 Przewodnik Instalacji

Przeglądaj online lub pobierz Przewodnik Instalacji dla Nie Sea gull lighting 94538-965. Sea Gull Lighting 94538-965 Installation Guide Instrukcja obsługi

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 1
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 0
1. Unthread cap from rail adapter (I).
2. Making sure contacts (A) will align with conductors (B) on rail,
set the bottom of the rail adapter (I) to the bottom of the rail
and “roll” rail adapter (I) up onto the rail.
3
.
C
lose hinged side of rail adapter (I) up onto rail and thread cap
back onto rail adapter (I).
4. Install lamp. Thread supplied lamp enclosure over lamp.
LR-122
062308
INSTALLATION AND SAFETY INSTRUCTIONS
www.SeaGullLighting.com
IMPORTANT SAFETY INSTRUCTIONS
INSTALLATION
Be sure the electricity to the system you are working on
is turned off; either the fuse removed or the circuit
breaker set at off.
For use with the 120V Transitions track series by
Sea Gull Lighting.
Caution – To reduce the risk of burn during relamping
remove from the track before relamping.
Use of other manufacturers components will void
warranty, listing, and create a potential safety hazard.
If you are unclear as to how to proceed, contact a
qualified electrician.
Minimum distance from the front of the lamp to
combustible surfaces is 8".
Make sure all connections are tight.
Dimming halogen lamps greatly reduces lamp life.
Turn off and allow to cool before replacing lamp.
Lamp gets HOT quickly! Contact switch only when
turning on.
Do not touch hot lens, guard, or enclosure.
Do not touch the lamp at any time. Use a soft cloth. Oil
from skin may damage lamp.
Do not operate the luminaire fitting with a missing or
damaged shield.
Save these instructions.
R
AIL
ADAPTER (I)
RETAINING
RING (M)
FIGURE 1
SHADE (J)
FIXTURE INSTALLATION
CORRECT INCORRECT
FIGURE 2
CONTACTS (A)
CONDUCTOR (B)
CONDUCTOR (B)
CONTACTS (A)
Przeglądanie stron 0
1

Podsumowanie treści

Strona 1 - CORRECT INCORRECT

1. Unthread cap from rail adapter (I).2. Making sure contacts (A) will align with conductors (B) on rail,set the bottom of the rail adapter (I) to the

Komentarze do niniejszej Instrukcji

Brak uwag