Sea gull lighting 7457-02 Przewodnik Instalacji Pobierz pdf

INSTALLATION AND SAFETY INSTRUCTIONS

FOR YOUR SAFETY ASSEMBLY

GENERAL

WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU

ARE WORKING ON IS SHUT OFF. EITHER THE FUSE REMOVED

OR THE CIRCUIT BREAKER OFF .

You don’t need special tools to install this fixture. Be sure to follow the

steps in the order given. Under no circumstances should a fixture be

hung on house electrical wires, nor should a swag type fixture be

installed on a ceiling which contains a radiant type heating system.

Read instructions carefully. If you are unclear as to how to proceed,

consult a qualified electrician.

Carefully remove the fixture from the carton and check that all parts

are included, as shown in Figure 1 & 2. Be careful not to misplace

any of the screws or parts which are needed to install this fixture.

GREEN

GROUNDING SCREW

*OUTLET BOX

SCREWS

MOUNTING

BAR (B)

*WIRE

CONNECTORS

MOUNTING

SCREWS (A)

*GROUND WIRE

*OUTLET BOX

GROUNDING AND MOUNTING BAR LOCK UP

FIGURE 2

*NOT INCLUDED

FIGURE 1

*NOT SUPPLIED

STEP 1:

*OUTLET BOX

CAP NUTS (F)

(if applicable)

INSULATION (E)

LOCKWASHER (D)

NUT (C)

MOUNTING BAR (B)

*WIRE CONNECTOR

*GROUND WIRE

GLASS (N)

(if applicable)

TRIM (M)

CORK WASHER (L)

FLANGED NUT (K)

NIPPLE (J)

LOCKNUT (I)

SOCKET (H)

CANOPY (G)

FINIAL (P)

ROUND NUT (Q)

GREEN

GROUNDING

SCREW

Attach socket (H) to canopy (G). NOTE: Socket (H) may be factory

installed. Pass wires through holes in canopy (G). Carefully lift up

edges of insulation (E) (if applicable), slide lockwasher (D) and

nut (C) down socket wire. Tighten nut (C) with pliers.

CAUTION: Press insulation (E) (if applicable), back into place after

socket (H) is installed.

FIGURE 3

DECORATIVE CUP (O)

SOCKET BRACKET (R)

MOUNTING SCREWS (A)

*OUTLET BOX SCREWS

Installation And Safety

Instruction

HC-121

092800

Fill In Item Number On Carton And

File This Sheet For Fixture Reference. ITEM#_______________

1 2

Installation And Safety 1
Instruction 1

Podsumowanie treści

Strona 1 - Instruction

INSTALLATION AND SAFETY INSTRUCTIONSFOR YOUR SAFETY ASSEMBLYGENERALWARNING: BE SURE THE ELECTRICITY TO THE WIRES YOUARE WORKING ON IS SHUT OFF. EITHER

Strona 2

Install lamps.Thread locknut (I) onto nipple (J) (about 3 turns) and thread that endof nipple (J) into socket (H). Tighten locknut (I) up to socket b

Komentarze do niniejszej Instrukcji

Brak uwag

Sea gull lighting 7457-02 Przewodnik Instalacji

Przeglądaj online lub pobierz Przewodnik Instalacji dla Nie Sea gull lighting 7457-02. Sea Gull Lighting 7457-02 Installation Guide Instrukcja obsługi

Podsumowanie treści

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Nie Sea gull lighting 7457-02