Sea gull lighting 59216LE-782 Przewodnik Instalacji

Przeglądaj online lub pobierz Przewodnik Instalacji dla Nie Sea gull lighting 59216LE-782. Sea Gull Lighting 59216LE-782 Installation Guide Instrukcja obsługi

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 2
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 0
INSTALLATION AND SAFETY INSTRUCTIONS
F
OR YOUR SAFETY
A
SSEMBLY
GENERAL
W
ARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU
ARE WORKING ON IS SHUT OFF. EITHER THE FUSE REMOVED
OR THE CIRCUIT BREAKER OFF .
You do not need any special tools to install this fixture. Be sure to fol-
low the steps in the order given. Read instructions carefully.
If you are
unclear as to how to proceed, consult a qualified electrician.
NOTE: In order for this lighting fixture to operate properly the
buildings electrical system must be grounded. If you are
unclear as to how to proceed, consult a qualified electrician.
S
TEP 1:
STEP 2:
Remove center cover (B) by squeezing cover together and pulling
out of tabs (C).
Remove 7/8” diameter wire exit plug and oval mounting knock-outs
by taking a screwdriver and punching out plug and knock-outs from
back side of fixture pan (A).
STEP 3:
Install (one) end cap (O) onto fixture pan (A). secure in place with
cap nut (E).
Do not install on a ceiling that would cause the lift and shift
m
echanism to disengage (ie. slope ceiling, drop
ceiling etc.)
NOTE: FOR FIXTURES PROVIDED WITH 75˚C OR 90˚C SUPPLY
WIRE WARNING ONLY-(THESE WARNINGS ARE PROVIDED ON
THE U.L. LABEL AND ON THE FIXTURE CARTON): RISK OF
FIRE. MOST DWELLINGS BUILT BEFORE 1985 HAVE SUPPLY
WIRE RATED 60˚C. CONSULT A QUALIFIED ELECTRICIAN
BEFORE INSTALLING.
TAB (C)
7/8" WIRE EXIT
MOUNTING HOLE
BALLAST
CENTER COVER (B)
FIXTURE PAN (A)
FIGURE 1
Installation And Safety
Instruction
HC-976
082206
Line art sho
wn ma
y not exactly matc
h the fixture enclosed.
Ho
wev
er
, the installation instructions do apply to this fixture.
Fill In Item Number On Carton And
F
ile
T
his Sheet F
or F
ixture Reference. ITEM#_______________
IF SUPPLY WIRES ARE LOCATED WITHIN 3" OF
BALLAST, USE WIRE RATED FOR AT LEAST 90˚C.
Przeglądanie stron 0
1 2

Podsumowanie treści

Strona 1

INSTALLATION AND SAFETY INSTRUCTIONSFOR YOUR SAFETYASSEMBLYGENERALWARNING: BE SURE THE ELECTRICITY TO THE WIRES YOUARE WORKING ON IS SHUT OFF. EITHER

Strona 2 - AT LEAST 90˚C

GROUP A: CONNECT TO BLACKHOUSE WIREBLACKWHITE*PARALLEL WIRE (ROUND & SMOOTH)*PARALLEL WIRE (SQUARE & RIDGED)GROUP B: CONNECT TO WHITEHOUSE WIR

Komentarze do niniejszej Instrukcji

Brak uwag